Jerry Hey wrote:
Paul, is there any way to use two of the Mazda primary
injector
fuel rails one with each of the the p port runners.? Each would
have
one high flow and one low flow injector?
Is it important to inject the fuel in line with the air flow
through
the runner, or can it be injected at an angle say 90 or 45
degrees?
Jerry
The center to center distance on a 1988 turbo fuel rail is 6.25
inches
roughly. What is the center to center distance on your P-port
tubes?
You want to get it as close to inline as you can. Mazda uses a
special
plastic insert with the 90 degree injectors mounted in the center
housing.
Paul Lamar
Jerry,
Have you considered mounting the injectors directly opposite the
bellmouth
openings of the runners (on/in the intake plenum) - room permitting.
This
gives the straightest line one can get or get a set of Paul's
runners
with
bellmouth and fuel injector mounts.
George (down under)
I have started thinking about putting the injectors INSIDE the bell
mouths. There is a compelling reason to do this
in that I want the runners to be a little less than 27 inches from
butterfly to bellmouth but it is very difficult to keep
them that short. We were going to turn the runners downward on the
cool side and install the injectors in the
turned down portion directly in line with the main runner but this
produces a runner that is too long. Paul's runners will not work
with
the p port.
Paul has some good suggestions that I need to think about and Ed is
working on this too. Hopefully we will come up with something good.
Jerry
27 inches is too long Jerry. 22 inches for 6000 RPM and something less
for 2.85:1
gear box and 7500 RPM. If you put them in the bell mouths they will
restrict
the airflow and spew fuel back because of the organ pipe tuning.
Paul Lamar
Here is the same drawing with the intake chopped off at 22 inches.
Jerry
I am assuming you are using a 180 degree bend with a 3 or 4 inch center line radius?
You can rotate, looking at the engine from the side, the tubes out or in to
reduce the height. Also I think you can shorten the four inch straight section
without binding the butterflies.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.