I have started thinking about putting the injectors INSIDE the
bell
mouths. There is a compelling reason to do this
in that I want the runners to be a little less than 27 inches from
butterfly to bellmouth but it is very difficult to keep
them that short. We were going to turn the runners downward on
the
cool side and install the injectors in the
turned down portion directly in line with the main runner but this
produces a runner that is too long. Paul's runners will not work
with
the p port.
Paul has some good suggestions that I need to think about and Ed is
working on this too. Hopefully we will come up with something
good.
Jerry
27 inches is too long Jerry. 22 inches for 6000 RPM and
something less for 2.85:1
gear box and 7500 RPM. If you put them in the bell mouths they
will restrict
the airflow and spew fuel back because of the organ pipe
tuning.
Paul Lamar
Jerry,
Paul is correct about the fuel "fogging" if you use the injectors
in
the bellmouth.
The F1 cars now sometimes use this system due to the ULTRA SHORT
intake
tract they are running. (About 3-4 inches) This is because the newer
5 valve
configurations run as much as 18K rpm in the NA formula. You could
do
this
if you run an airbox around the bellmouths. (hint make it as big as
you can)
A welded on bung would probably be better.
Bill Jepson
Bill, we have always planned on having an airbox around the
bellmouths. Are you saying that with the air box, the straight in
injectors will work? Jerry
First it must be well sealed and then have an excess fuel drain
overboard
or return to the tank. The Formula one guys use the injectors shooting
straight down and they are not particularly concerned if some fuel fog
is lost overboard.
Paul Lamar
In this photo are the injectors looking directly at the intake valves
with no runners at all? Do the injectors operate just when the valve
opens or are continuously spraying? What happens in the rotary with
Tracy's injection? Jerry
As Bill pointed out the runners are short and yes you can probably see
the intakes valves by looking down the runners.
All good questions. In the case of the Renault I have no idea but I doubt
the injection event is timed to the intake valve opening because at 18,000 RPM
it might be hard for the injectors to keep up. Besides there probably is no
difference in HP one way or the other. Timed injection probably works well
at low RPM's. I'll have to let Tracy answer that as I don't have the source
code to Tracy fuel injector computer's software.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.