> paul wrote:
> > >
> > > Hi all....On a typical aircraft prop installtion, the heads of the prop
> > > bolts are drilled and then safety wired. This works, because the prop
> flange
> > > has fixed threaded sleeves into which the prop bolts fasten. On my Ross
> > > PSRU, there are thru-bolts, and instead of the bolts being threaded into
> a
> > > fixed unit, they go through the crush plate on the engine side of the
> prop
> > > and have locknuts instead. What might be the best method of securing
> these
> > > type of prop bolts? Unfortunately, I have seen a few other rotary
> > > installations with a Ross redrive, but never bothered to look to see if
> the
> > > prop bolts had safety wire, etc. Thanks for any and all suggestions.
> Paul
> > > Conner, 13b powered SQ2000 transporting to the airport today.
> >
> > In theory if you have lock nuts you don't need safety wire.
> >
> > Paul Lamar
> The classic SAE 1 and 2 prop flanges for wood props have hat shaped
> threaded bushings pressed in from the back side. These bushings are also
> the drive lugs for the wood prop - you should not count on the bolts
> to drive a wood prop - metal is a different story. Vance
Not to be a pain or anything, but safety wire anything that you don't want to fall off!
For prop bolts with nuts I would suggest a AN bolt with the hole in the threaded end
and castle nuts. Torque them up and use washers if needed to expose the hole.
Small cotter keys or safety wire will then do the trick. I agree with Vance that the
bushings should be used. That way the bolts are only a tension item, which is the
correct way to use them.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.