Paul Carey wrote:

Hi Paul

We are placing our blown 20B on an engine dyno, and the dyno mob need

the dimensions of the rotary end housing bolt pattern at the gearbox face,
and the eccentric shaft dimensions where the flywheel

bolts on.

Would you or any other members have those drawings and dimensions?

Regards PC

Paul Carey LAME MC
Aero Group Pty Ltd
P.O.Box 119, Maylands WA 6931
Ph (08) 9371 5205  Fax: (08) 9371 9644  Mob: 0418 959 892
www.aeromanagement.com.au

I have the bolt pattern for the bell housings.

Paul Lamar

Paul Carey wrote:

Hi Paul

Can you re-send that gif - could not read it.

Thanks PC

Paul Carey LAME MC
Aero Group Pty Ltd
P.O.Box 119, Maylands WA 6931
Ph (08) 9371 5205  Fax: (08) 9371 9644  Mob: 0418 959 892
www.aeromanagement.com.au

If you save that Paul and print it the printer will size it so you can read it.


Never the less I'll try sending a different one.

Paul Lamar

Careful Paul(s), if you have a stock 20B rear housing on that engine, it is the automatic tranny one and is missing a bolt and has a different starter config.
Marc Wiese

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.