Jerry Hey wrote:
Paul and Perry Mick, First, can the Long EZ handle the weight of the
turbo RX8 with Tracy's drive? Secondly, with the very narrow
firewall and also the short S-beam, do you think a mount can be
designed that will clear the turbo? I have been asked to build an
engine mount for this configuration and am just beginning to come to
grips with the project. Thanks, Jerry
Yes on the first question.
Yes on the second question too. Make the side beams look like this.
Your customer will have to beef up those silly aluminum angles used to attach
the motor mounts to a Long EZ. We had a set crack a couple of weeks ago
at the Camarillo air show. Klause had his crack too. Replace them
with bent up 4130 steel angles.
Paul Lamar
Paul's drawing looks very similar to mine. I have doubts about squeezing
a turbo into a Long-EZ. You could make it work with various bumps on the
cowl I suppose. My rad is very small, and you can see the one in Paul's
drawing is also very small, it is about the largest you can fit under
there, at only about 14" wide by 17" long. It is barely capable of
keeping up with my 120 HP, so if you are making 200 HP you will probably
need more rad.
I made the Schertz beam integral with the oil pan and moved the rear
mounts rearward and slightly inward, but overall width is still slightly
wider than what I have now, and can't make it much wider. Putting them
back like I did also gets the rubber mount away from the oil port at the
lower left rear of the engine.
I have the aluminum pan and aluminum mount parts fabricated, will soon
be welding up the steel frame.
Perry
This is my first try at the cowl. It needs a few adjustments here and there.
The intercooler could be rotated 90 degree and placed along side the cool
part of the engine. The wing strakes are not shown but would help.
This is a four inch prop extension but a six inch would help more.
I can fit a longer rad no problem. The compressor can be indexed
to get rid of the compressed air pipe sticking through the cowl.
I'll make some changes in the original installation 3D and do another
cowl. It is a 100 times faster doing it in 3D rather than doing a real
installation :)
BTW guys I think I have the thrust line off. How far above the top
of the spar is the thrust line?
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.