<< Paul, I would like to buy one of the Mazda Racing competition oil
coolers.
I need to find someone who can help me here. Perhaps Lynn? I have
talked to
several RX-7 SCCA racers that saw as much as
15° F improvement in temps with just the cooler change. I was told
that
the race cooler was the same size as the largest 13B single cooler,
that was
nose mounted in the car. The technology is
supposed to be similar to the '86 cooler with internal turbolators
in the
tubes. Expensive but effective. Those of you running cars please let
me know
what you think. The size shouldn't be a problem
for me.
Bill Jepson
I have never owned one of those things but have seen many racers use
them to
good effect when left under the radiator. I have three Setrabs that
seem to
get the job done.
Lynn E. Hanover
Is that an RX8 body you are running Lynn?
Do you have a picture of how the air exits the rad. Looks like they
are right
under the hood. I assume the sheet metal is cut away on the intake
side.
I hope Mazda Speed is giving you money :)
Paul Lamar
Bill I talked to the Mazda Speed people at 7 Stock and all you need do
to buy direct
is show proof of running a solo event. Do you have any friends with
Mazda cars
that meet that requirement? You could probably pay for your club dues
out of
the savings. Racing Beat list that oil cooler in the 2001 price list
at $858!!
Looks like a simple one pass oil cooler wider by 1-1/2 inch. 6.5
inches wide
by 22.5 inches long by 2 inches thick. Still sounds marginal for a
three rotor
in aircraft use.
I think all Mazda oil coolers have turbulators. I am still
researching that. I am getting ready to cut the tanks off a couple I
have
lying around to check for turbulators and then send them to Ed for new
end tanks.
BTW Jerry, Mazda Speed is asking $1200 for a factory peripheral port
rotor housing.
Paul Lamar
I am not surprised. The price may be for a new housing that they
install an insert in. That is what Racing Beat does. Last year when
I was looking into this, all the p port housings, regardless of the
retailer, seemed to originate from Racing Beat. Certainly, the
$1200.00 does not include the throttle body which they would want a lot
of money for, no doubt. In a couple more days, I will be able to
announce the price of our set up. It will be a very good deal. I
hope that just about every one adopts the p port intake as the ideal
aircraft set up. I can't see any reason in any case for retaining
the stock porting. Should be tempting to those trying to shoe horn in
a turbo, too. jerry
This one is a special casting.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.