Jerry Hey wrote:
Hi Paul, the p ports are finished. Nice to say that after two
years
or work. Here is a photo of the port on the inside of the housing.
We are going to make a few changes in the throttle body to shorten
it,
but the basic design is set.
I am now ready and able to offer p porting of customer supplied
housings, complete with throttle bodies installed and ready to run
for
$850.00 per housing. Ed will soon have the rest of the intake
available. Regards, Jerry
I'm a little confused. How will the soft aluminum end of the port
wear
while the engine is running. I thought a coating was applied on the
inside of the housing.
Chris Cosman
Chris, all the p ports I have seen are aluminum inserts. The seals
ride on the housing surface next to the insert and therefore cannot
wear into the insert.. The exhaust port opening is wider than our
insert and the seals do not protrude into it as the rotor sweeps by.
If they did, they would slam into the upper edge and break. Anyway,
that is how I think it works. Jerry
Makes sense.
Chris C.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.