Subject: Revised Rotor verses the Piston 3
From: ACRE
Date: 9/23/2004, 7:26 PM


Hi Paul,

The motion of the piston is a sine wave and you can get a the
exact
value for the instantaneous acceleration by taking the
derivative of
the
motion.  (My wife is waiting to go to dinner, so I can't think
about
it
right now, but it's pretty straightforward.)

Bob White

--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (soon)

When you get a chance please explain in layman's terms and we will
rewrite it.

Paul Lamar


While Bob is enjoying his dinner, I will give it a try.

Besides a distorted sine wave due to the connecting rod (it gets
shorter
along the
piston travel direction at the 3 and 9 o'clock positions), one can
simply use the
acceleration of a rotating body and add a + or - value for the ratio
of
crank
radius ?r? to connecting rod length ?l? for TDC and BDC positions.

Angular velocity: w  = Pi * n / 30,  here: w = 3.14 * 2500 /30 = 262
Rad/s.

Acceleration: acc = w^2 * r, here, acc = 262 * 262 * 5?/12 = 28,600
ft
per sec per
sec.

(Also: acc = velocity ^2 / r. Velocity = r * Pi * n / 360 = 5? *
3.14 *
2500 / 360
= 109.1 ft/sec
Acc = v^2/r = 109 * 109 / 5 * 12 = 28,600 Rad/sec^2. )

The maximum acceleration is at TDC where velocity is zero, a peak is
also at BDC,
while the acceleration is zero at maximum velocity near 3 and 9
o'clock
positions.
When the crankshaft rotates 90 degrees from TDC the piston has move
down
more than
half its travel.

Here the ratio of r/l comes into play, which is between .25 to .30
or
more,
normally about .28 in automotive engines.

This value has to be added at TDC and subtracted at BDC. TDC =
1+.28,
BDC = 1-
.28= .72.

So, maximum acceleration at
TDC is 28,600 * 1.28 = 36,600 ft / sec^2, and at
BDC = 28,600 * 0.72 = 20,600 ft/sec^2.
Accelerations at all other crank positions are in between these two
values.

For positions at a certain crank angle sin- and cos- functions of
the
rotation
angle and the value r/l apply.  Likely Bob will explain this, (after
dessert).

Regards
Rolf

Rolf,
I followed your math but I don't understand why the R/1 of .28 is added
at TDC and subtracted at BDC???  It seems like it should be added at BDC
as well. Also, I didn't see where rod length is factored, with a short
rod accelerating faster from TDC and BDC than a long rod (the benefits
of this is always a hot debate around car guys; it does seem that the
longer rod would result in lower side loads on the piston).

Ken Powell

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.