snips
Rolf,
I followed your math but I don't understand why the R/1 of .28
is
added
at TDC and subtracted at BDC??? It seems like it should be
added at
BDC
as well. Also, I didn't see where rod length is factored, with a
short
rod accelerating faster from TDC and BDC than a long rod (the
benefits
of this is always a hot debate around car guys; it does seem
that
the
longer rod would result in lower side loads on the piston).
Ken Powell
Hi Ken and Bob,
Ken the R/1 should read R/L where L is the length of the connecting
rod.
I know a small ?l? can easily be confused with a 1.
The connecting rod length in this example is about 9 ? long, perhaps
a
bit less. Hence R/L = 2.5 / 9 = .278. This length is just an
assumption.
They are generally in that neighborhood.
By this ratio R/L the length of the connecting rod is accounted for.
The
impact on acceleration is exactly that of its value. I think 28 % is
not
small.
Now, how to explain the addition and subtraction of this value?
Assuming the piston is halfway down. Draw a circle from the centre
of
the wrist pin with the radius of the connecting rod length. This
circle
passes through the centre of the crankshaft and cuts the
radius of the crank throw above the centre line of the crankshaft.
This is where the piston is near its maximum velocity. The maximum
speed
of the piston occurs when the crank radius and the connecting rod form
an
angle of 90 degrees. This is nearby, at about 15.5
degrees slope upwards from a horizontal line through the centre of
the
crankshaft.
It follows that from this maximum velocity, where acceleration is
zero,
the rotation angle of the crankshaft, and therewith the time, is
shorter
around the top for for TDC than it is for BDC.
Consequently the acceleration is larger at TDC and smaller at BDC.
Or
said differently, acceleration is larger at TDC and smaller at BDC
than
the acceleration of a rotating body, here the crankpin.
The formula for the crank pin acceleration is simply: acc = w^2 * r,
where ?w? is the angular velocity in Rad/s, w = Pi * n /30, ?n? is rpm
and
?r? is the crank radius.
Another way to look at is to split the circle in half and calculate
from
3 and 9 o?clock positions. As we all know at 3 and 9 o?clock crank
locations the piston is more than half way down. The
vertical length of the connecting rod is only 8.65 inches; hence the
piston is .35 inches lower. The upper travel is 2.5 + .35 = 2.85?, the
lower travel is 2.5 - .35 = 2.15?. The time is the same
for both, it follows that the acceleration of the piston varies from
that of the crank pin. It is higher around the top and it is lower
around
the bottom. Easy.
Luckily, the increase and decrease is the same, and is also the same
as
the ratio of R/L, that is crank radius over connecting rod length. So
it
becomes an easy calculation for TDC and BDC.
The instantaneous acceleration at any crank angle is a bit more
complicated and beyond this Forum, I think.
Rolf Pfeiffer
I agree. That is why I explained it in the article in generalities.
Paul Lamar
Rolf,
Thanks for the great explanation and education. Being able to draw a
picture really helped to visualize this concept.
Ken Powell
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.