Subject: SQ2000 successful taxi test today
From: ACRE
Date: 9/27/2004, 1:12 PM


paul wrote:

Hi, fellow rotary enthusiasts....Finally hooked up my radio antennas so I
could taxi the 13b powered SQ2000 under it's own power today.  Running
rich
at lower idle speeds, but smoothes out around 1500 rpm's.  I ran it up
and
down the taxiway several times, then back to the hangar, shut it down and
felt the radiator and oil cooler to make sure the radiator was warm at
both
the top and bottom.  After approximately 4 engine starts and taxi runs,
water temp was approaching 210 F so I taxied back to the hangar and shut
it
down. Oil temps got up to 160.(stock Mazda oil cooler) after   about 5
minutes of cool-down time, the water temp was back to 190 or less.  No
visible oil or water leaks.  I am now pretty sure I am running a little
rich, because during one engine start, the engine was faltering, so I
momentarily turned off the high pressure fuel pump, and it smoothed out
immediately. When it sounded like it was going to run out of fuel (only a
few seconds later), I turned the fuel pump back on and the engine
continued
running.  On one pass down the taxiway, I got up to around 4000 rpm and
the
aircraft was accelerating very rapidly.  I have no doubt this engine has
enough power to fly this aircraft.  When it is not running rich, it is an
EXTREMELY smooth engine.  I just finished re-reading my MicroTech manual,
and since I have the handheld keypad (panel-mounted, actually), it is
very
easy to change the mixture. I should be doing more testing and tuning in
the
next few days, and I will advise. Right now, I have to try to wipe this
silly grin off my face.  Keep building, guys (and girls), when you
actually
get to start the engine and taxi your creation, the fun begins.  Paul
Conner, 13b powered (NA) SQ2000 in Mobile, AL


Paul:

Congratulations on your first taxi test!

Yes, the handheld keypad is the answer to the excessive richness at idle.  I
discovered on my 20B that it idles best at a leaner setting than what is
acceptable for takeoff and climb.  I had a good engine man stand outside the
cockpit and advise on mixture settings based on sight and sound.  I couldn't
always hear the differences in the cockpit.

It only gets better from here.....

Tom Parkes
20B Lancair ES

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.