Lynn,
Have you or any of your friends got any experience with the Barnes

pumps?

They have a nice LOOKING lobe style pump that I am interested in. Thanks

Thanks again.
Bill Jepson

I did not see a three section pump in the line, but they might make one

for

you.
The five section pumps are used on V-8s, where they recover scavenge oil

from

the sump in two places, the rear of the right valve cover and the right

side

of the valley to keep spent lifter oil from falling onto the crank.

The three tooth gears looks like a bad idea from the pressure pulse

peaks

might be off the scale. Aluminum coolers have the short fatigue life of

aluminum.

The iron or steel pressure section looks like a very good idea. I may do

that

the next time my Peterson splits open.

I have never seen a Barnes pump. The model powered by the camshaft are
usually found on sprint cars. I would not put the new rectangular

Peterson on

anything that requires reliability.

Lynn E. Hanover

Lynn,
Another thing I don't understand is - with a flat plate engine sump how does
the scavenge pump keep primed without a sump to hold some oil. It just seems
it will start sucking air at anytime ( considering attitude) and lose prime.
George (down under)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.