Subject: TX flex plate to Tracy's redrive.
From: ACRE
Date: 10/1/2004, 2:41 PM


Bulent,
What did you do to make it compatible, then? I would be interested in
seeing pictures....Tracy did tell me the 3rd gen flywheel does not fit
his redrive, either. Did you modify the one you had?
Marc W.


Mark,

To my knowledge there are only two diameters in flywheels.
1. the manual flywheel - 298mm ( including 12A).
2. the TX Flexplate - 320mm.
3. Later manual flywheel ( year?) 320mm

Paul is correct to say there are differences, as the differences I've seen
in the flexplate vary in shape and depth.
There could also be different mounting points for the isolators as well as
different splines on the clutchplate centres for different years.  What
Tracy uses, I'm unsure.

I can't say I've seen a Cosmos, I may have, but am unsure!

However I can't see the difficulty in making one fit ( I suppose it's extra
work when you can get the right one) Or getting one made from steel or
aluminium, provided you know the dimensions that suite Tracy's unit i.e.
year/ model.

The aftermarket people have all the necessary dimensions and just order an
aftermarket flywheel to suite 'X' year. What year did you say Paul ?

If your going to make one yourself or have one made by a local machinist,
get a flexplate ( the right one) and copy the dimensions.

The ring gear on the manuals are a tap-on fit and can be tapped off with a
hammer and the auto's are tack welded and the welds can be can be  ground
off, with care.

George (down under)

It is not just the diameter. It has to due mostly with Tracy's GB input shaft lenght.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.