Paul Carey wrote:
Hi Paul
We recently had to strip our blown alcohol 20B down due to a blower backfire
shearing the eccentric shaft keys again (even though we double keyed it 180
apart). I am purchasing a billet eccentric shaft new from New Zealand, as
ours was damaged. The billet shafts are harder, straighter and lighter than
stock, for about $2,000AUS.
We are going to PP the engine whilst we have it apart, to get more power.
Using 52mm round ports, in a position to give power from 4500 to 9000. One
injector as close to the housing as possible on each runner, then one about
6 inches back, then injectors in the hat above the blower (this is
mechanical constant flow injection) and different pressure check valves
bringing in each set at different revs. The butterflies are in the hat at
the top. Each runner will be 55mm ID at about 18 inches long to the plenum.
Any comments or advice would be appreciated.
Regards PC
Paul Carey
Aero Group Pty Ltd
226 Railway Parade, Bayswater WA 6050
P.O.Box 119, Maylands WA 6930
Ph: (08) 9371 5205 Fax: (08) 9371 9644 Mob: 0418 959 892
Tracy Crook wrote:
Paul, would you share the info on who makes those billet 20B cranks? There appears
to be zero new > cranks available from Mazda since they have devoted 100% of Mfg.
capability to RX-8 production.
Tracy
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.