Subject: Turbo P-Port? 20B E-shaft availabilty.
From: ACRE
Date: 10/3/2004, 9:29 PM


Paul Carey wrote:

Hi Paul

We recently had to strip our blown alcohol 20B down due to a blower
backfire
shearing the eccentric shaft keys again (even though we double keyed it
180
apart). I am purchasing a billet eccentric shaft new from New Zealand,
as
ours was damaged. The billet shafts are harder, straighter and lighter
than
stock, for about $2,000AUS.

We are going to PP the engine whilst we have it apart, to get more
power.
Using 52mm round ports, in a position to give power from 4500 to 9000.
One
injector as close to the housing as possible on each runner, then one
about
6 inches back, then injectors in the hat above the blower (this is
mechanical constant flow injection) and different pressure check valves
bringing in each set at different revs. The butterflies are in the hat
at
the top. Each runner will be 55mm ID at about 18 inches long to the
plenum.

Any comments or advice would be appreciated.

Regards PC

Paul Carey
Aero Group Pty Ltd
226 Railway Parade, Bayswater WA 6050
P.O.Box 119, Maylands WA 6930
Ph: (08) 9371 5205  Fax: (08) 9371 9644  Mob: 0418 959 892


Tracy Crook wrote:

Paul, would you share the info on who makes those billet 20B cranks?
There appears
to be zero new > cranks available from Mazda since they have devoted 100%
of Mfg.
capability to RX-8 production.

Tracy

Paul Carey wrote:

Hi Tracy

Tracy - I can get you a new Mazda shaft from Japan :-) Guy in my crew lived
in Japan for 8 years, and has two Cosmo's he bought new there. He has some
rather good contacts.

Eccentric shaft supplier details:

Precision Engineering Ltd
9B Airborne Road
North Harbour Rd
Auckland NZ 1311
Contact: Jeff
Ph (09) 415 3264
Fax (09) 415 3266

By the way Tracey, the apex seals you supplied are going great. Survived
some pretty serious boost and blower backfires in our 20B, and they are
bedding in better and better - 125psi on the compression tester.

Regards Paul

Paul or Alex, what are the guys using for intemediate housings on the four rotor?
Also is the four rotor shaft joint just like the three rotor shaft joint?

Thanks.

Paul Lamar

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.