Subject: TX flex plate to Tracy's redrive
From: ACRE
Date: 10/5/2004, 8:03 PM


     > >>>> Flywheels from 20B and 13B Cosmo don't fit Tracy's
redrive,
and you
     > >>> can not
     > >>>> replace them with other 13B flywheels. I have tried.
     > >>>> Bulent

     > >> My 20B is equipped with a 2nd gen flywheel.   Fits just
fine.
Maybe I don't
     > >> understand the problem.
     > >>
     > >> Tracy  (finally got electricity back)

     > The problem is that I wanted to use the original starter.
It
straddles the
     > engine block and the bellhousing. So I could not use the
2nd gen
flywheel.
     > The bellhousing gave me 3" "free" prop extension.
     > Bulent

Tracy Crook wrote:

     I think you will find that it is far from "free" before the
project
is complete.  I don't have any problem with builders doing their own
thing
but there is always a cost (usually
     high) with modifications to any existing system.

     Tracy  (watching runway disappear under the Suwannee river :
)

Take pictures Tracy :)

Paul Lamar


 Bulent,
That Cosmo Bellhousing doesn't look to bad, but if I can quote Butch ,
'Auto
bellhousings aren't designed for Aircraft Gyroscopic forces'.

The free prop extension is also a good advantage, but as I suspected
that
free cost  is going to be severely diminished with the modifications
you
want.
I would get a quote for that extended shaft from Tracy before you did
a cost
comparison.
My thoughts FWIW.
George (down under)

I also seek the side benefit of an extended nose in order to better fit
the engine smoothly into the custom cowling. Besides I like the stock
starter arrangement of the auto tx engines much better. I will be using
the Cosmo sedan bell housing that had the 20B in it.
Marc W.

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.