Trip mileage over to Copper State (LA to Phoenix) was roughly
was 20.4 MPG using the fill the fuel tank method. Cruise speed was
mostly 80 MPH 95% of the time.
The low oil warning light comes on at 80 MPH (4000 RPM) after an an hour
or so with an OAT of 95 F to 100 F. It will go off at 77 MPH (3850 RPM) after
a few minutes and then will come back on in a few minutes if you
speed back up to 80 MPH. My guess is there is a drain back problem
or oil foaming problem with the low profile RX8 oil pan.
To get four quarts in the engine with that low profile oil pan Mazda must
be counting on some of the oil being in the engine itself.
There is just not enough volume in the pan itself. I stopped
to check the oil level and after about 5 minutes delay it was
no more than a half a quart low. I put what I thought was a half a
quart in.
It happened again a while later and again I stopped to check the oil
level again. This time it was no more than a 1/4 quart low. It does
take some time for the oil to drain down so you are instructed in the
owners manual to wait a few minutes before you check the oil level.
BTW Mazda please put a longer dip stick tube on the engine as it
is hard for me to get my big hand down in there to check the oil
level. Particularly while still keeping the sleeve of my shirt from
getting dirty :)
Here is a cut away of the 2nd gen center housing. The RX8 center
housing externally looks very similar to this. The black part
south of the large center hole to the bottom of the housing will probably
hold a 1/2 to 3/4 of a quart. This I think is what Mazda is
counting as part of the oil reservoir.
I don't know what oil pan Tracy is using but he is reporting
oil misting coming out of the vent at a steady 7000 RPM.
Bruce has modified Tracy's RX8 center housing to save weight.
Bruce cutaway part of the stock Mazda cast iron venting system so I think
that may be another problem entirely. Bruce may have out smarted
himself :) Picture 2
Bottom line is: plan on using and older style deep oil pan if
you are planing on using an RX8 motor until we get a better handle
on this problem or until Mazda comes up with an answer.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.