Subject: Alcohol in fuel and composite tanks.
From: ACRE
Date: 10/11/2004, 3:08 PM

Performance Data

A minor drawback of the use of ethanol fuel is the slightly reduced range. A
liter of ethanol produces about two-thirds the heat of a liter of avgas.
However, the effect of range loss is reduced by the higher thermodynamic
efficiency of ethanol. A Cessna 152 fitted with a Lycoming 235N2C engine
uses about 13.8 liters/100 km on avgas and 15.7 liters/100 km on ethanol.

The high octane level of ethanol allows the use of higher compression ratio
engines that deliver more power for the same throttle setting. The lower
Reid vapor pressure of ethanol helps to prevent vapor locking. Ethanol is
cooler and cleaner in use than avgas and is more resistant to detonation,
resulting in fewer vibrations and longer engine life. "

Doug in Japan

But the alcohol ruins epoxy tanks in no time!
That is not a minor issue

Jerzy


Very good point Jerzy.

Paul Lamar


Brian Alley wrote:

Doug, Any composite tank should be coated internally
with Jeffco Novolac. Jeffco developed Novolac to coat
the inside of comercial tanks used to store acids and
alkyes. Nothing in any fuel will damage this coating.

=====
BRIAN ALLEY (N320WT)
CARBON FIBER COMPOSITES
304-872-7938 shop
304-562-6800 home


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.