<< These are good points to consider when evaluating a different design/
> shape. I particularly like the explanation on the pressure drop-off
( in the large cavity) allowing droplets to drop out of suspension. I've
noticed
> this in steam pipes as well, where a larger diameter tube will cause water
> droplets to drop out of suspension.
>
> Do you think we would need to increase the breather tube diameter at the
RPM
> we are running? Something to watch for I guess!
> George (down under) >>
I would run the stock breather tube as tall as the space will allow. Then the
hose to the catch can as large a diameter as can be used (up to the diameter
of the fill tube) and then into a tall catch tank with an opening to the air
larger than the breather hose. That again to reduce any breather gas velocity
to a point even lower than that in the hose. So that spent oil stays in the
catch can once there.
In this picture, the blue dash 12 breather hose is from the top of the
storage tank.
The original filler pipe location since replaced with a plug and a dash 10
fitting, also runs to the top of the storage tank. The smaller hose is the
transmission breather.
Note the large opening at the top of the catch can.
In this dry sump engine, air enters the engine from the storage tank, through
the dash 10 hose. So flow is reversed. Scavenge oil and blowby gasses are
removed by the two scavenge pumps, cooled in two Setrabs and filtered in two
Peterson inline filters and returned to the storage tank at a tangent and below a
flat baffle that has a hole in the center. The gasses are released and escape
though the hole, out the breather hose (dash 12) and into the catch tank. The
engine breaths through the scavenge system and when blowby gas volume is too
low, as in high RPM closed throttle, below ambient pressure develops inside the
engine, and air is drawn in through the dash 10 hose from the top of the
storage tank.
It sounds much more complex than it is.
Lynn E. Hanover
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.