Trip mileage over to Copper State (LA to Phoenix) was roughly
was 20.4 MPG using the fill the fuel tank method. Cruise speed was
mostly 80 MPH 95% of the time.
The low oil warning light comes on at 80 MPH (4000 RPM) after an an hour
or so with an OAT of 95 F to 100 F. It will go off at 77 MPH (3850 RPM) after
a few minutes and then will come back on in a few minutes if you
speed back up to 80 MPH. My guess is there is a drain back problem
or oil foaming problem with the low profile RX8 oil pan.
To get four quarts in the engine with that low profile oil pan Mazda must
be counting on some of the oil being in the engine itself.
There is just not enough volume in the pan itself. I stopped
to check the oil level and after about 5 minutes delay it was
no more than a half a quart low. I put what I thought was a half a
quart in.
It happened again a while later and again I stopped to check the oil
level again. This time it was no more than a 1/4 quart low. It does
take some time for the oil to drain down so you are instructed in the
owners manual to wait a few minutes before you check the oil level.
BTW Mazda please put a longer dip stick tube on the engine as it
is hard for me to get my big hand down in there to check the oil
level. Particularly while still keeping the sleeve of my shirt from
getting dirty :)
snips...
Paul Lamar
My mistake. Mazda came out with a fix on this problem. They replace the oil
pan. Here is part of the service bulletin. Get it fixed while the car is still
under warrantee.
Makes me wonder if Mazda is testing these cars before release in North America. I would
be happy to test new Mazda rotary powered cars for free :)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.