I have been fooling around with the 3D again and I decided
to change the Reno racer design. I always worried about those belt
drives taking 1000 HP. This design uses two Bell 47 final drive
gear cases just like Dave Garber's airplane. According to Bell they are
good for 1000 HP at 6000 RPM input revs.
Sort of a half or 3/4 scale P38. The liquid to air intercoolers
are fed with acetone and dry ice. The pilot will sit behind the
spar.
Paul Lamar
Paul
Have you been watching Star Wars again? How far back is the racing pod?
Actually the design looks very interesting. Say I wanted to ask you if the
main landing gear is electric or hydraulic? I am weighing the plus and
minuses for incorporating an electric gear actuation system for the SeaWind.
A well sealed electric linear gear drive motor should be lighter than the
electric/hydraulic system with all of its valves, oil tank, emergency manual
hand crank and plumbing etc. The SeaWind will land in water but the
present design cylinder is in a dry environment.
Doug in Japan
I used the RX8 electric rack and pinion steering gear.
We have to keep it all Mazda :)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.