Matt Prather wrote:
I am sure this is obvious, but we'll need to be sure to calculate the
wing area, planform, airfoil for pulling 2-4g's all the way around the
course. Another place where lighter weight = better performance. If
the wing is too small for the load factor, induced drag will rise.
Unlike the Pond Racer, but like other Rutan designs, maybe locate the
cockpit in the left nacelle behind one engine - left to make it easier
to see who you are passing. That might dictate an assymetric wing
planform, but it would remove a bunch of intersection drag associated
with having a seperate cockpit. Think single seat Boomerang... It's
more structurally efficient as well. If you are frightened by
assymetry, locate the radiators and electricals in the corresponding
place in the right nacelle. Tailwheel(s).
MAP
I'll need both booms for cooling systems. I'll add those shortly.
The hole in the end of the boom will be the cooling air outlet.
Hopefully we will get a bit less cooling drag if not a slight
amount of thrust.
Paul Lamar
Okay, then how about 3 engines? :) One on the centerline as well
as the two outboard. Then single tail surface...
MAP
Yea that's a good idea. A tri motor Reno racer. No replacement for displacement!
Compared to a Merlin or an R3350 three rotors are cheap.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.