Subject: Alcohol in fuel and composite tanks.
From: ACRE
Date: 10/18/2004, 9:40 PM


 > >>>>> Charlie,
 >>>>>
 >>>>> Going back to 27 th Feb 2002, you recommended  a 2 part polymer,
 >>>>> polysulphide from Morton Chemical.
 >>>>> I kept this info as I know how much a problem this can be.
 >>>>>
 >>>>> There are also coatings recommended and sold by Wicks and Spruce(
 >> can't
 >>>>> remember what they are).
 >>>>>
 >>>>> So what do you think of this Jeffco Novelac ?
 >>>>> George (down under)
 >>>>
 >>>>
 >>>> George,


 >>>> Polysulfide is a type of rubber.  I have never tested it in gasohol but
 >> it does have an excellent reputation for being resistant to very, very
 >> aggressive solvents.  Whether this would extend to gasohol fuel is not
 >> personally known to me but the performance of fluorinated
polymers are well
 >> characterized.  The automobile industry does not use polysulfide for one
 >> reason, it is extremely expensive and it is not promoted by the
 >> manufacturer.  BTW, Morton does not make this material anymore.
I believe
 >> they got out of the business a year or two ago.  I understand it is being
 >> made in France; probably by a division of Total.
 >>>>
 >>>> I used the Jeffco product to seal my tanks based on how it performed in
 >> the gasohol fuel testing I did.  Gasohol is deadly compared to
most anything
 >> else you might put into the tank.  I wanted to use polysulfide but it was
 >> going to cost about $400 to go that route and I did the job
with Jeffco for
 >> about $100.  The Jeffco is just not nearly as flexible as polysulfide.
 >>>>
 >>>> As a side note, I understand from my colleagues in Europe
that biodiesel
 >> (RME) can also be quite aggressive in the high pressure common rail fuel
 >> injection systems.  It seems they run under very high pressure
causing the
 >> fuel to get hot as it recirculates.  With the presence of water, the fuel
 >> can decompose to form a highly oxidizing acid that attacks rubber
 >> components.  This may be something to keep in mind when
deciding on rubber
 >> parts or inspection schedules for those types of fuels.
 >>>>
 >>>> Charlie Smith
 >>>> KIS Cruiser 4021


 >> Charlie,
 >> Thanks , that clears that up for me !
 >> George (down under)
 >
  Charlie


 You are definitely right about RME. If can be quite aggressive IF the
 producer didn't properly process the fuel. Sometimes glycerol remains and
 that is definitely water absorbent and combined with traces of caustic soda,
 and soap and methanol is corrosive and can carbonize the engine. It it so
 easy to make that sometimes people make it to easy and don't test it at each
 processing stage

 Doug in Japan


   The fuel tanks in the wings I am currently flying on are made from
Dow 411-350 vinyl ester resin and I did not slosh the tanks and have
had no problems and I use gasohol.  I am now making a new set of
wings and have considered sloshing these  tanks.
  Also note that the Randolph sloshing compound that is alcohol
resistant is  vinyl ester based.

   Ken

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.