Subject: Alcohol in fuel and composite tanks.
From: ACRE
Date: 10/18/2004, 12:30 PM


Charlie,

Going back to 27 th Feb 2002, you recommended  a 2 part polymer,
polysulphide from Morton Chemical.
I kept this info as I know how much a problem this can be.

There are also coatings recommended and sold by Wicks and Spruce(
can't
remember what they are).

So what do you think of this Jeffco Novelac ?
George (down under)


George,


Polysulfide is a type of rubber.  I have never tested it in gasohol but
it does have an excellent reputation for being resistant to very, very
aggressive solvents.  Whether this would extend to gasohol fuel is not
personally known to me but the performance of fluorinated polymers are well
characterized.  The automobile industry does not use polysulfide for one
reason, it is extremely expensive and it is not promoted by the
manufacturer.  BTW, Morton does not make this material anymore.  I believe
they got out of the business a year or two ago.  I understand it is being
made in France; probably by a division of Total.

I used the Jeffco product to seal my tanks based on how it performed in
the gasohol fuel testing I did.  Gasohol is deadly compared to most anything
else you might put into the tank.  I wanted to use polysulfide but it was
going to cost about $400 to go that route and I did the job with Jeffco for
about $100.  The Jeffco is just not nearly as flexible as polysulfide.

As a side note, I understand from my colleagues in Europe that biodiesel
(RME) can also be quite aggressive in the high pressure common rail fuel
injection systems.  It seems they run under very high pressure causing the
fuel to get hot as it recirculates.  With the presence of water, the fuel
can decompose to form a highly oxidizing acid that attacks rubber
components.  This may be something to keep in mind when deciding on rubber
parts or inspection schedules for those types of fuels.

Charlie Smith
KIS Cruiser 4021


Charlie,
Thanks , that clears that up for me !
George (down under)

 Charlie


You are definitely right about RME. If can be quite aggressive IF the
producer didn't properly process the fuel. Sometimes glycerol remains and
that is definitely water absorbent and combined with traces of caustic soda,
and soap and methanol is corrosive and can carbonize the engine. It it so
easy to make that sometimes people make it to easy and don't test it at each
processing stage

Doug in Japan

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.