Subject: Frontal area advantages of the rotary.
From: ACRE
Date: 10/18/2004, 9:40 PM


Robert,
What we all share ( in this group) is a genuine interest in Aviation
and the
development of the Rotary engine, any Rotary engine for that matter,
that
would be suitable for aircraft use.
We have one member ( perhaps more), Chris Cosman, who has designed his
aircraft to specifically use the Rotary - which is a good move IMHO.

There are those ( of this group) who are endeavouring to make an
installation more user friendly (to coin a phrase).

I personally would like to see what you have in mind for your design.
You will get much support and advice on here (Acre).
George (down under)

Robert Clark - CAD/Graphics wrote:

Thank you George for the kind words and being clear on the intent of the
group for I am new to the group, and have lots to learn.

  I will scan some sketches and see I can get some modeling done to
display the projects (yes I have multiple Projects).  Know how do I post
Pictures?  Can I include them in the text e-mail?


Robert Clark
CAD/Graphics Planner
KBR - Houston, Texas
(713) 753-2390

Yes but try to keep them less than 100K.
If they are larger send them anyway as I can reduce them if I have to.

Paul Lamar

  I am curious Paul. What is it that would make a design specially suited to
a Mazda? It seems that several very conventional designs are being
built and applied with rotary power with what appear to be good
results - what would you revise? - Vance

In the case of the Reno racer Sports class the frontal area can be reduced
due to to the narrowness of the rotary engine.  So far in my iterations
the fuselage max cross section (mostly width) is determined by the pilot. 
I am laying him back about 40 degrees which is about as far as one can go 
and still be comfortable. I spent a lot of time on this over the last
three days.

The cowl taper can also be improved due to the overall small cross 
section of the rotary. Combining the intake manifold and the air to liquid
intercooler also helps to keep down the cross section of the engine and 
hence the taper of the nose. One can almost get the engine completely hidden
by a 14 inch diameter spinner (shown in this 3D drawing) let alone the 19 inch 
diameter spinner John Sharp is using on the Nemesis Next.

The horizontal rad above the engine is about 30 inches long by 20 inches wide
and two inches thick for a core volume of about 1100 cubic inches.

For my next trick I am going to incorporate the oil cooler in the oil pan 
for a further reduction in frontal area and engine over all package volume.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.