Subject: New Reno Racer design Landing gear
From: ACRE
Date: 10/18/2004, 12:17 PM


I have been fooling around with the 3D again and I decided to
change the Reno racer design. I always worried about those belt
drives taking 1000 HP. This design uses two Bell 47 final drive
gear cases just like Dave Garber's airplane. According to Bell
they are good for 1000 HP at 6000 RPM input revs.

Sort of a half or 3/4 scale P38. The liquid to air intercoolers
are fed with acetone and dry ice. The pilot will sit behind the
spar.

Paul Lamar


Paul

Have you been watching Star Wars again?  How far back is the racing
pod? Actually the design looks very interesting.  Say I wanted to
ask you if the main landing gear is electric or hydraulic?  I am
weighing the plus and minuses for incorporating an electric gear
actuation system for the SeaWind. A well sealed electric linear gear
drive motor should be lighter than the electric/hydraulic system
with all of its valves, oil tank, emergency manual hand crank and
plumbing etc.  The  SeaWind will land in water but the present
design cylinder is in a dry environment.

Doug in Japan

I used the RX8 electric rack and pinion steering gear.
We have to keep it all Mazda :)

Paul Lamar

More info on the RX8 rack and pinion.

Paul Lamar

-"Giffen A. Marr" wrote:


Paul
Was your use of the Mazda Rack and Pinion with separate actuators for each
gear leg?
Giff Marr
LIV-P/20B 27%

No. You only need one. Here is a bottom view. When the rack moves to the
left it pulls up the right gear leg and pushes up the left gear leg.

Paul Lamar


Paul

Great.  The steering rod connections becomes the emergency crank in case of
motor failure.  Now all I need to know is how robust the unit is.

Doug in Japan

Good question.

Paul Lamar

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.