Subject: Combined oil pan and oil cooler.
From: ACRE
Date: 10/19/2004, 9:52 PM

This is a combined oil cooler and oil pan. The over all construction
can be much lighter in weight than a traditional oil cooler as the tubes 
are not required to withstand 100 psi oil pressures. Everything  functions 
under atmospheric pressure more or less. There no oil pressure drop as would
be the case in a traditional oil cooler as well.

This is about twice as deep as the stock oil pan to hold
the full gallon of oil. From about 3 inches to 6 inches deep
as about half the volume is taken up by fore and aft rectangular
air tubes.

It also will remove the foam from the oil due to the large surface
area of the cooling channels. Best way if not the only way to make
it is use aluminum furnace brazing techniques. The air tubes
with internal fins are .2 inches wide as are the oil drain channels
between them. there are no fins in the oil channels but they could
be added if more heat transfer between the oil and the aluminum was required.
That would of course probably reduces the oil drain back speed so that should
be tested first.

It is not recommended for slow airplanes as the length is a bit long
for good air flow at 100 MPH where the dynamic pressure required to force
air down the air tubes is only .18 psi.  

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.