The horizontal rad above the engine is about 30 inches long by 20 inches wide
and two inches thick for a core volume of about 1100 cubic inches.
For my next trick I am going to incorporate the oil cooler in the oil pan
for a further reduction in frontal area and engine over all package volume.
Paul Lamar
Paul, I love the low frontal area aspects of the rotary, as you do. I would
seriously rethink the exhaust exit though. A great deal of drag caused by
that pipe location and its wake. You probably figured to do that later. On
the acre web site you show the P-47 turbo layout. With the turbo turned
to a different angle an exhaust that trails into the slipstream should be
possible. I always thought a horizontal fish-tail under the cowl would be
cool!
Bill Jepson
The exhaust and intake pipes are not finalized. I'll wait until I figure
out the wing. Any suggestions for a good airfoil to use for Reno?
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.