Matt Prather wrote:
I haven't taken a thermo class, but I know that rapid flow of the cooled
fluid is not necessarily the best for tranfer of heat. Rapid flow can
cause
turbulence which is detrimental to heat transfer. Slow movement over
a large surface area is probably better.
Paul, were you intending for the gravity head pressure of the hot oil to
be
the force causing flow through the cooler? Can the oil to get into the
pump
pickup only by draining through the cooler? If so, I think that would
work
well. However, if hot oil can get to the pump without draining through
the
cooler, I think that is a problem.
I can think of two other issues. The system is not inverted capable. Not
a big issue, since lots of aircraft systems also aren't.
The other (and probably more serious) concern is how will it work when
the oil is cold. It seems like you might need some kind of bypass valve
so that thick oil can get to the pickup without passing through the
cooler.
Regards,
Matt-
I think you are wrong about the turbulence bit Matt.
Turbulence causes the molecules near the surface to interchange position
with molecules not so near the surface thereby improving the heat transfer
to more of the fluid. "Turbulators" are added to the interior of oil cooler
tubes for that reason. If you check the fins on most radiators you will also
see little louvers punched into the fins designed to increase air
turbulence.
I have heard of laminar flow oil coolers but I suspect
that they work by drastically decreasing the distance between metal
surfaces.
Yes on the gravity flow.
Yes on the oil getting into the pick up area at the bottom of the pan.
There is about an inch of solid oil in the bottom for the oil pump pick
up screen to suck from. A pocket for this would be better I suspect.
I agree the sustained invert capability is lacking.
I also agree on the cold thick oil problem but I run 15W 50 Mobile one and
it is pretty thin right from the get go. Up north I have no experience
with it. The drain back space between the tubes in this version is .2
inches.
That could be increased if this proves to be a problem.
Paul Lamar
Paul,
You'll get better heat transfer with synthetic oil in the sump than
someone will get with petroleum. The uniformity of the molecular structure
of the synthetic will allow for easier turbulence, while the mixture of
structures in petroleum oil will tend toward stratification and reduce
turbulence. The turbulence and reduced friction of the synthetic is worth a
20-50 degree temperature reduction.
M1 15w-50 has a pour point of -45 C (-49F). It will pour here, but will
be like cool honey. Rule of thumb is to add 20 degrees to the pour point to
'guestimate' where the oil will be usable - in this case, minus 25C or minus
13F.
All oils will become more viscous when cold, but it's the paraffin in
petroleum oil that solidifies. Synthetics don't have the waxes.
Andy Hecker
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.