Subject: Combined oil pan and oil cooler.
From: ACRE
Date: 10/21/2004, 11:25 AM


This is a combined oil cooler and oil pan. The over all construction
can be much lighter in weight than a traditional oil cooler as the
tubes
are not required to withstand 100 psi oil pressures. Everything
functions
under atmospheric pressure more or less. There no oil pressure drop
as
would
be the case in a traditional oil cooler as well.

This is about twice as deep as the stock oil pan to hold
the full gallon of oil. From about 3 inches to 6 inches deep
as about half the volume is taken up by fore and aft rectangular
air tubes.

It also will remove the foam from the oil due to the large surface
area of the cooling channels. Best way if not the only way to make
it is use aluminum furnace brazing techniques. The air tubes
with internal fins are .2 inches wide as are the oil drain channels
between them. there are no fins in the oil channels but they could
be added if more heat transfer between the oil and the aluminum was
required.
That would of course probably reduces the oil drain back speed so
that
should
be tested first.

It is not recommended for slow airplanes as the length is a bit long
for good air flow at 100 MPH where the dynamic pressure required to
force
air down the air tubes is only .18 psi.

Paul Lamar


Paul,
You seem to have a lot of surface area with this design, which is good
--
because you are going to need it. The oil that you are removing the
heat
from in the oil pan is essentially quiescent (sp?), it will be flowing
very
slowly across the heat transfer surface, essentially by natural
convection
as it dribbles down the channels from the top of the oil pan to the
pick-up
point on the bottom. The average velocity in an oil channel will be
much
lower than in a conventional Mazda oil cooler, because there are more
channels.

The trade-off will be whether the increased surface area compensates
for the
lower heat transfer coefficient on the oil side.

Bill Schertz
KIS Cruiser # 4045

Yes I totally agree Bill. Performance is very questionably. One thing it
has going for it
is the air tubes are always surrounded by oil. The oil level would be
right
up to the top of the pan. It is a configuration not covered in the Kays
& London
Compact Heat Exchanger book to my knowledge. Would be interesting
to build and test a small scale version using a hot plate and pump to
continuously heat
a small quantity of oil. Perhaps I can get a thermo  professor at UCLA
to
do an analysis or a test set up. We could try that with and without fins
on the
oil side.

Another problem is the length of the air channels. By the time the air
gets to the
back of the pan the air temp should be significantly higher reducing the
delta
T and therefore the rate of heat transfer.

I think it might also benefit from a thermal insulator between pan and
engine.

It remains an interesting idea and would simplify the under the cowl
situation if it
worked.

Paul Lamar


"Kent, Russell" wrote:

Turning the pan 90 degrees (as I said in an earlier message) has the
useful side effect of making the tubes shorter and more numerous.

Russell Kent


Yes I picked up on that right away. Great idea Russell. Thanks again.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.