Dave by now you must have gotten the failed parts out of your
turbo. Can I borrow them. I have a metallurgist friend of mine at UCLA
that can take a look and perhaps analyze the turbine metal.
Paul Lamar
DaveLeonard wrote:
Paul, right you are. The ACRE list was down while I was doing all the
discussing of the incident. It is clear to me (and I did the
post mortem),
that the failure was a fatigue failure of the axle, which
caused the turbine
to hit the walls of the housing. Of course, the failure of the axle may
have been preceded by a failure of one of the blades.
I was able to drive out, plug up the oil passages, and fly it
home in one
afternoon. Static RPM was down to 4100 but that was still
enough to get me
and all my tools up to 8000 (in 95 deg heat) and back home. I
have since
adjusted the timing better and gotten the Static RPM up to 4600. I have
just completed the rest of the TEMPORARY conversion to n.a. I
must say that
it sure does simplify the look under the cowl and there is
about 20 lbs of
stuff in the 'turbo stuff' box. But I really miss having the available
power at altitude.
Here are the pictures of the 'post.'
You are welcome to the turbine.
Dave Leonard
Hard to tell anything from these photos. Can you ship the residue to me?
It would help me convince a UCLA Prof. to help analyze this if I had
some failed hardware to show him :) They like that sort of stuff :)
Sort of a mystery challenge.
BTW Dave did you have an EGT probe on there?
Paul Lamar
Of course. Although I gave up looking at it too closely. Anytime I was
running reasonable power the EGT would be around 900 C (1650F). EGT would
decrease with power, especially under about 25" MAP. The extremes of
mixture could bring it down to the 880 [1616 F]range - but that was also associated
with a significant decrease in power. That day was no exception. Running
at less than 910 [1670 F] the whole time, usually about 890.
Once I got settled on an altitude I usually lean to 890 [1634 F]. Seemed to be just
above the point where I would sometimes start getting a lean surge with RPM
changes.
Dave Leonard
That 100 degrees makes a big difference in the strength. Perhaps what we have here
is blade resonance combined with blade bending, high temp and high turbine RPM
I suspect the easiest thing to fix is lower turbine RPM.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.