Subject: Dave Leonards failed stock turbo parts
From: ACRE
Date: 10/21/2004, 11:24 AM


Dave by now you must have gotten the failed parts out of your
turbo. Can I borrow them. I have a metallurgist friend of mine at UCLA
that can take a look and perhaps analyze the turbine metal.

Paul Lamar


DaveLeonard wrote:

Paul, right you are.  The ACRE list was down while I was doing all the
discussing of the incident.  It is clear to me (and I did the post mortem),
that the failure was a fatigue failure of the axle, which caused the turbine
to hit the walls of the housing.  Of course, the failure of the axle may
have been preceded by a failure of one of the blades.

I was able to drive out, plug up the oil passages, and fly it home in one
afternoon.  Static RPM was down to 4100 but that was still enough to get me
and all my tools up to 8000 (in 95 deg heat) and back home.  I have since
adjusted the timing better and gotten the Static RPM up to 4600.  I have
just completed the rest of the TEMPORARY conversion to n.a.  I must say that
it sure does simplify the look under the cowl and there is about 20 lbs of
stuff in the 'turbo stuff' box.  But I really miss having the available
power at altitude.

Here are the pictures of the 'post.'

You are welcome to the turbine.

Dave Leonard

Hard to tell anything from these photos. Can you ship the residue to me?
It would help me convince a UCLA Prof. to help analyze this if I had 
some failed hardware to show him :) They like that sort of stuff :)
Sort of a mystery challenge.

BTW Dave did you have an EGT probe on there?

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.