Subject: Combined oil pan and oil cooler.
From: ACRE
Date: 10/22/2004, 2:55 PM


Paul,
This is only a suggestion - how about a wedge shaped duct to the side
of the pan and another on the other side to take the hot air away.
This should reduce the distance the air has to travel, the wedge
should provide increased pressure/density and therefore heat transfer.
George (down under)

Wedge shaped ducts on the outlet side are a no no.
The air needs to comes straight out for at least ten inches.
Here are some K&M graphs on the subject.


Paul Lamar

Dave Arbogast wrote:

What if we stagged the air tubes like this:

x x x x x x x x
 x x x x x x x
x x x x x x x x
 x x x x x x x

Or, is this what you had in mind? It would add to the turbulence and
transfer.
-dave

That would work fine and almost all aircraft rads were built like that
up until the 1950's or so. I think it went away because it was more costly
to make than a plate and fin design.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.