Subject: Rotary-Round-up Lake City Florida
From: ACRE
Date: 10/31/2004, 6:02 PM

I was only there on Saturday so I can't give you a comprehensive
overview of all the things that happened. Tracy Crook gave a brief talk
on his experience so far with the RX8 engine in his airplane.
The most significant thing so far IMHO is the EGT is way down
from what it was. Tracy says he was seeing as much as 1800 F at full
power max EGT before and now it is 200 to 250 F lower than that.
That bodes well for future turbocharged RX8 engines.
He feels some of the lost heat is going into the cooling system.
All old stock engines heated the cool side of the block to 
reduce the banana distortion effect. The cool side of the block is now about 
18 degrees F higher due to the heating by the side exhaust ports.

The rest of the reduction in EGT is due to a more efficient engine.

Another thing he mentioned is the large delta T he is seeing in
the air flowing through the evap cores. As much as 70 degrees F.
This results in a 150 degree F under cowl temp. If this is also
true of Dave Leonard's airplane with a similar system wherein
used cooling air is dumped into the cowl. That could easily explain
why Dave Leonard's water radiator is not working up to expectations.
My guess on Dave's water radiator volume is about 600 to 700 cubic
inches and should be entirely adequate if it were getting cool
ambient air. The rule of thumb is one degree increase in initial
cooling air temp is a one percent loss in cooling effectiveness.
That would make Dave's water system up to 50% less effective.

Tracy had initially had a long 2.5" SCAT hose and NACA duct feeding the
intake air plenum. He felt the long scat hose was picking up
heat from the under cowl temp and loosing several inches of manifold
pressure. IMHO the ineffective NACA duct also had a role in this situation.
the engine felt down on power compared to the 2nd gen engine.

He changed the duct to a short ram air scoop and picked up a couple
of inches of manifold pressure over and above sea level numbers
at high speed. Picture attached below.

Tracy noticed a 20 or 30 degree F reduction in oil temps and he thinks
perhaps it is due to the ceramic coating he had done on his RX8 rotors.
Oil temp is now 180 degrees F. Tracy uses a Kays & London simple wedge
shaped diffuser with the stock 2nd gen oil cooler mounted long ways in the
right side of the cowl. The right side stock Vans RV4 cowl air intake is enlarged
and feeds both the right evap core and the oil cooler.

With only eight hours on the RX8 engine he guesses the best BSFC may be .46 
instead of .47 based on the slightly improved MPG he is getting.  Max RPM
in the air is 7400. IMHO he would do better with a shorter prop than 73"
with more blade area.... top speed wise. Top speed is currently only 220 MPH.

Tracy is not using the stock iridium plugs in the new RX8 engine. Formerly
he got about 250 hours on the 2nd gen plugs burning auto gas. About 100 hours
or less burning 100 LL aviation fuel.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.