Tracy came up with this heat shrink tubing hose clamp.
I am not sure who makes it but we will probably be
hearing more about it in the future. Tracy likes it because it is light
weight. No doubt about that. It requires a heavy duty heat gun
to install. You remove it by cutting it with an Exacto knife
and using a new one. My gut tells me to be cautious
but Tracy thinks it is a good idea and time will tell. Me... I would
rather use a mechanical Breeze constant torque hose clamp because you
can tell if it is torqued properly and therefore it is obvious it is
applying the requisite clamping pressure.
Paul Lamar
-Bob Perkinson wrote:
Here is another view of the hose clamp that Tracy is using. He is using
Silicone tape as a sacrificial spacer so the hose wont be cut if the clamp
has to be removed.
Bob Perkinson
Hendersonville, TN.
RV9A
If Nothing Changes
Nothing Changes!
Thanks Bob. Much better picture.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.