Subject: possible new hydraulic cs planetary reduction
From: ACRE
Date: 11/3/2004, 11:59 AM


     > > > >Marc Wiese wrote:
     > > > > >
     > > > > > No disrespect to Tracy or to Mistral or to Marcotte:
     > > > > > Just to gauge the water here; who would be interested in purchasing from
     > > > > > a reliable experienced manufacturer (builds aircraft/engines of all
     > > > > > sorts), a hydraulic constant speed reduction drive with a 2.92 reduction
     > > > > > ratio that would mate to a Mazda? Provisions for a governor would be
     > > > > > included as well. Sort of like a more realistically priced Mistral
     > > > > > unit~$3000-$3500?
     > > > > > I'm looking into it. Very possible early next year in limited
     > > > > > quantities.
     > > > > > Marc Wiese
     > > >
     > > > I'm interested, keep me posted.
     > > > jmpcrftr at teleport dot com
     > > >
     > > > Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
     > > > 13B in gestation mode, RD-1C, EC-2

     > FYI, the unit is Russian made. The factory has already made it and used it on a helicopter @ 1000 ft lbs and 400 hp. It needs to be adapted to our uses. It was used on a dry sump engine.
     I will keep you informed if and when it actually happens!
     > Let me ask this question: there are so few of these cs units in use (planetaries on Mazdas with cs), where does the oil from the cs unit dump-the internal housing and then gravity drain
     to the sump? There will be a lot of flow. Also, the Marcotte is said to require an additioal oil cooler because it heats the oil so. Is anyone flying a Marcotte or any cs unit that could
     confirm this?
     > MW


     No offence taken here Marc.  If they can make this thing happen, that's great.  I would caution that almost every geardrive maker I've seen underestimates what it takes to make CS really
     happen.  One that looks like they knew what it really took was a Crossflow engine installation where they integrated a governor mount on the redrive.  The option cost alone was quoted at
     $8000.00  which did not include the cost of the prop itself.  Mistral may be doing this as well but I have not seen the details or price on it.

     I started to design CS into the RD-1x drives but when I found out what the working pressures were (400 - 1200 PSI depending on what "expert" I talked to) I put it on the back burner.  The
     governor itself would also be a considerable challenge.

     Tracy Crook

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.