Bill,
I just can't seem to visualise in my mind, what you are

saying -

a flat

plate restricting the exhaust flow, seems counter productive?
A small drawing would help!
George (down under)

George I'll do a drawing. The way to think about it is this,
think of the standard round canister with one flat slice on the

primeter. Very little restriction but it forces the flow to be
turbulent. The cool tube concept could still be used.

Bill Jepson

Ok George, Here's the muffler drawing I promised.
I hope all will now become clear!
Bill Jepson

Ben Schneider wrote:

Looks as if it would make it much easier to build too. Leave the flat
plate off until the rest of the muffler is finished, then weld the plate
on.

  Ben Schneider--

Thanks Bill,
However nothing like what I expected, and I'm wondering  if it would be
easier to build it out of square if the shape works so good.
Something to consider for Jerry!
I will certainly try that down the track.

George (down under)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.