Of the pumps listed above, the ones I see come through my shop are
mostly Meziere, and Stewart. I have called Meziere on occasion, and they
are
great with technical answers.
As far as the big drag engines, many are now going to forged blocks.
(about $7800. empty) No water jackets.
The nitro burners are so tempremental, that leaving the start with a 30-40
deg.
block temp variation means a difference in hp.
The records for top fuel now are: Elapsed Time= 4.44 and 333.4 mph.
Archie
Archie do you have any curves of back pressure verses GPM verses current
drain
for any of these electric pumps?
Do the heads have water jackets? I assume they do as there would be no need
for a pump.
Paul Lamar
Paul Carey wrote:
Hi Archie and Paul
Yes - the large V8's do have billet blocks and heads. I would dearly love
to convert the end and middle plates on the 20B to billet, and fill the
housings full of grout, but the cost just scares me at the moment. Until
then I still have the water system problems, and finding all the tricks to
give an optimum tune based on the temps at the time.
Regards Paul
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.