Subject: HP required to over come drag in radiators.
From: ACRE
Date: 11/9/2004, 10:58 AM

This is an interesting chart from Kays and London's book Compact Heat Exchangers.
It directly shows the HP required  to overcome friction drag
in the radiator for a given rate of heat transfer. Putting this another
way it is the key to cooling drag.

Obviously it is highly configuration sensitive. By that I mean
it depends on the fin spacing and tube spacing as well as the thickness
of the material. It also depends on the Reynolds number which, simplified, is
the ratio of the length of the fin to the air velocity.

Apparently as the velocity of the air changes in the heat exchanger
the efficiency of the radiator increases or decreases. Interesting.

Of course we have little control over this and are forced to use
what radiators are available. We can however look at the details
of a radiator and compare them to configurations in Kays and London
and perhaps choose something that is more suited to our purposes.
For example comparing a evaporator core with a water radiator.

This does not, as far as I can tell, address the pressure drop through
the water tubes or the HP required to pump a given amount of water
per minute through those tubes. That is probably in the book but I have
yet to run across it.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.