Subject: HP required to over come drag in radiators.
From: ACRE
Date: 11/10/2004, 3:44 PM


George Lendich wrote:


Paul,
My thoughts in regard to limiting drag, maximizing density and
velocity -
is
to first identify the air flow restriction ( through the Radiator)
which
ever radiator you plan to use, and place a pressure sensor in the
inlet,
with an adjustable pressure release valve to the cowl and exit.
Is that too complex ?
George ( down under)

No but it sounds like a cowl flap :) Which is an excellent idea.

Paul Lamar

george wright wrote:

question.  it seems to me that the temperature of the airflow downstream
of
the radiator is an indicator of heat transfer efficiency or the adequacy
of
the inlet flow for a given speed condition.  I seem to remember that one
of
Tony Bingelis's books had something about a heat based bellows actuator
used
on Porsche engines that he'd seen as an automatic cowl flap actuator.
Perhaps you design for the worst case flow condition and use something
similar to vary the inlet as needed.  The outlet would be fixed area for
the
worst condition which should minimize back flow, the delta P should
allow
good flow through the radiator.  I suppose you could also "pump" it with
an
ejector, but I wonder about the packaging and its effects on firewall
forward cross-section?

You need to know two things. The temperature and the volume of flow.

Bill Schertz addressed those issues with his presentation at Rotary
Roundup
You can download a complete pdf of his presentation at Bob White's web
site.

http://www.bob-white.com/ACRE/

In the mean time here is one of Bill's pertinent charts.

Yes. Tony advocated the use of a air cooled VW thermostat to control
the cowl flap. Here is an old sketch and simple calcualtion I did on
the subject awhile back.

Paul Lamar

Paul,
Yes a cowl flap, Or just releasing excess incoming air into the cowl for
general cooling, finding it's way to a low pressure outlet -providing it
doesn't create any cowl back-pressure to any other cooling requirements like
the Radiator or Intercooler etc.

To address George Wright's concern on the frontal area, the 'worst scenario
opening is a good suggestion as the possibility of excess drag is eliminated
with the 'flow-through' concept.

Just perhaps this could be a good idea for the radiator as well, by
eliminating excess drag while optimising pressure and velocity through the
radiator.

My thinking is that a system of  testing radiators for maximum cooling could
be developed to cover most radiator types - which could be easily carried
out by individual builders, and a simple system of testing for entry
pressure OR exit temperature ( also a good suggestion).

If this system involves exit cowls or vortex extractors, could depend on
individual needs or beyond the norm requirements.

The discussion on radiators and complexities of heat transfer helps to
understand the vagaries of cooling, but perhaps instead of concentrating on
inlet sizes and exit configurations - the inlet ( radiator) pressure  or the
exit ( radiator) temp, might be the simpler solution.

I suppose it doesn't have to be that complex, but only a simple flap
manually adjusted, releasing the excess inlet pressure into the cowl or
exit, while watching the engine temperature (oil or water).

Perhaps and ECU could automatically adjust a small flap ( or two) depending
upon the engine temps. There are a large range of options!

George (down under)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.