Barber Law Firm wrote:

Paul,

Are you still selling the intake parts that I have seen in the past?  If so, the obvious question is current pricing and delivery time and order process?  As always, thanks.

All the best,

Chris



Christopher Barber<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" />

Attorney and Counselor at Law



"Serving the needs of Senior Texans"

Barber Law Firm
11930 S Sam Houston Pkwy E
Suite 103
Houston, Texas 77089-4755
281-464-LAWS (5297)

CBarber@TexasAttorney.net
www.TexasAttorney.net

I have one or two sets left. You might have to do a tiny bit of tig welding
on the intake manifold  as I think it is undersize by about 1/4 inch where
a mounting bolt needs to go. You will also have to do a bit of port matching
with a die grinder.

Four intake runners/injection holders and one
13B intake manifold casting is $420 Plus $15 for shipping. When these are 
gone I won't do another batch until I get my NC mill up and running
and then they will probably fit only the RX8 high power version.

Send check to 830 East Santa Maria St suite 303
Santa Paula CA 93060

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.