Paul,

Will this new curved design clear the mount for the KIS Crusier?
This
looks a lot more interesting to me than the previous version with
the
straight out the side exit.

Nice going Jerry.

Charlie Smith
KIS Cruiser 4021

The simple one with the side view only curved works fine Charlie.
You need to check the dimensions closely as it is a rather tight fit
between the motor mount tubes. What does you motor mount look like.
Schertz box beam or what. Do you have a picture of the mount?

Paul Lamar

Bear in mind that blasting a stream of exhaust out perpendicular to
the
flight path is a drag hog.

Bill Schertz
KIS Cruiser # 4045

For some, the vertical pipe will be the only possibility but for most
the pipe can be sloped back.  In every case, there will be less drag
than created by  hanging a muffler under the fuselage.   In my case, I
plan to tack a little piece of half round ss to the leading edge of the
pipe where it is in the air stream, only an inch or so.    Jerry

BTW Jerry, I think it is a good idea in the future if you do a motor mount
for somebody you do the muffler at the same time to be sure it fits.

Paul Lamar

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.