Jerry Hey wrote:
Does anyone see a problem with supplying air to the cool tube as
shown
in the drawing? Also, could slowing the air inside the tube by
slightly restricting the outlet be beneficial? The purpose would
be
to make sure cool air contacted 100 per cent of the inner surface
of
the cool tube. If it just swirls in from the inlet, might there
be
hot spots? Jerry
Jerry Hey
j-winddesigns@thegrid.net
You won't get any airflow unless you hook the 1-1/2 inch tube to a
source
of dynamic pressure. Restricting the out let will hurt rather than
help.
If you really want to cool the tube better you need internal
fins. No easy way to do that.
Paul Lamar
Paul and Jerry,
There is an easy way to put fins in the 2' cool tube - if you put
them in
before you weld the 2" tube into the 6" tube.
Just drill some holes directly through the 2 " tube and weld in what
you
want ( flat or round) - weld from the outside.
You could probably leave them long, which would cause some swirling in
the
inside of the 6" tube as well.
Just a suggestion!
George (down under)
Ben Schneider wrote:
Water heaters have a swirling insert in the flue tube. It is inserted from
the top and just hangs there. Obviously you would have to do as George
suggested and drill a few holes along the length of the 2 inch tube and
weld it in place, but it would be easy to make. Take a piece of flat
stock, and put in several twists, slide it into the tube and weld in
place.
Ducking for cover,
Ben Schneider N713R RV7 Renesis, RD1C, EC2, Catto Prop.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.