Subject: cool tube inlet
From: ACRE
Date: 11/16/2004, 9:05 PM


George (down under) wrote:
Paul and Jerry,
There is an easy way to put fins in the  2' cool tube - if you put
them in
before you weld the 2" tube into the 6" tube.

Just drill some holes directly through the 2 " tube and weld in what
you
want ( flat or round) - weld from the outside.
You could probably leave them long, which would cause some swirling in
the
inside of the 6" tube as well.


Unless I misunderstand you, George, the labor involved in welding in
fins as you wrote (above) would seem prohibitive.  But putting a few
rods (a dozen or so) through the tube pre-assembly (as you wrote) might
be good for introducing and maintaining turbulence inside the cool tube
without unnecessarily restricting flow.  I wonder how much of the
thermal transfer (cool tube metal to cool tube air) will be conduction
and how much radiation though.  Turbulence is good for the former but
useless for the latter.

As for leaving the rods long (so that they protrude into the hot
section), I wouldn't.  Recall that the whole reason we made the cool
tube muffler was to cool the exhaust gases a little because they are so
hot that they melt common exhaust system metals.  Any rods in that "blow
torch" are likely to melt off, and may choose to do so at very
inopportune times.  (Spewing red hot flecks of metal onto the ramp
during climb out might make a pretty night takeoff, but it isn't going
to win you any friends...) On that basis I'd probably grind the weld
spots down to the contour of the tube.

Russell Kent

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.