Subject: cool tube inlet
From: ACRE
Date: 11/16/2004, 9:06 PM


Jerry Hey wrote:

Does anyone see a problem with supplying air to the cool tube as
shown
in the drawing?   Also,  could slowing the air inside the tube by
slightly restricting the outlet be beneficial?   The purpose would
be
to make sure  cool air contacted 100 per cent of the inner surface
of the cool  tube.  If it just swirls in from the inlet, might
there be
hot spots?     Jerry

Jerry Hey
j-winddesigns@thegrid.net

You won't get any airflow unless you hook the 1-1/2 inch tube to a
source of dynamic pressure. Restricting the out let will hurt rather

than help.

If you really want to cool the tube better you need internal fins.
No easy way to do that.

Paul Lamar

Let me try again:
  The purpose of the 1.5 feed tube is to clear the S beam so that air
can be taken from the front of the cowl (I thought that was obvious),
Air will  be blasting through the cool tube.  But swirling air does
not
necessarily touch all surfaces,   so I asked about slowing it down a
bit.        Jerry


You could coil up a screen door spring inside the cool tube if you want
fins

Chuck

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.