Jerry Hey wrote:

I mounted the Setrab oil coolers today.  The S-beam engine mount
provided a perfect shock absorbing attachment point.  I welded a 5" x
1.375" x 058 bushing to the top washer in the Barry mount stack.   To
this is welded a tray that the Setrab sets in.  Eventually, there will
be a shock absorbing material between the oil cooler and the tray.  The
entire assembly can pivot at the Barry mount, so one does not need to
worry about holding the final position during construction.   Jerry

Jerry,
I'm very impressed !
Are they smaller than a stock cooler and is that why your using two?
George (down under)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.