Subject: prop gov on distributor shaft
From: ACRE
Date: 11/18/2004, 8:24 PM


     > > http://www.alternate-airpower.com/Mikaelsen.html
     > >
     > > I ran accross this site that had a prop governor grafted onto the distributor
     > drive......any thoughts if this would work with Mazda's layout? The 20B comes to
     > mind as well as the pre FD engines that do not have crank triggers that could be
     > converted to such.
     > > Marc Wiese
     >
     > That guy is in for some major surprises as far as power and cooling are
     > concerned.
     > You need turbo's at 13,000 feet.
     >
     > That is a pretty good idea. Might work for us. The crank angle sensor
     > gear ratio is usually 2:1 so that would put the prop governor at about
     > the right speed or half engine speed.
     >
     > Tracy's PSRU output shaft is already partially drilled to supply oil
     > to the planetary gear set. One would have to drill it all the way forward
     > and take the oil out of the governor oil pressure boast pump and feed
     > it to Tracy's PSRU. Tracy's PSRU would then be operating at about twice
     > engine oil pressure. I don't see a real problem with that. The gov could
     > be mounted about where the stock Mazda metering pump is mounted to keep
     > the height down. Getting engine oil into the prop gov is no problem
     > with a plate adaptor as shown in the #11 photo.
     >
     > Does everybody follow this or do we need a schematic?
     >
     > Paul Lamar


      Schematic please Paul !! Do you think the drive gear of the 13B

     eccentric shaft and the driven gear on the  sensor will be up to

     the load of driving a prop govenor ?



     Kelly Troyer

I don't know but the gears and drive shaft can always be changed.
I took a closer look at Tracy's prop shaft today and it is already drilled from
one end to the other. Since the oil pressure out of the gov can be up
to 275 psi there will need to be a restrictor pressed into the prop shaft to limit
the oil flow to the gears. Tracy's plain aft prop shaft bearing should work OK
on 275 psi oil I think. This will have to be tried to be sure.
I'll work on an overall schematic shortly. This could be a real break through
in CS props for the rotary.

Here is some more info on it.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.