Subject: prop gov on distributor shaft
From: ACRE
Date: 11/18/2004, 11:02 AM


http://www.alternate-airpower.com/Mikaelsen.html

I ran accross this site that had a prop governor grafted onto the distributor drive......any thoughts if this would work with Mazda's layout? The 20B comes to mind as well as the pre FD engines that do not have crank triggers that could be converted to such.
Marc Wiese

That guy is in for some major surprises as far as power and cooling are concerned.
You need turbo's at 13,000 feet.

That is a pretty good idea. Might work for us. The crank angle sensor 
gear ratio is usually 2:1 so that would put the prop governor at about 
the right speed or half engine speed.

Tracy's PSRU output shaft is already partially drilled to supply oil
to the planetary gear set. One would have to drill it all the way forward
and take the oil out of the governor oil pressure boast pump and feed
it to Tracy's PSRU. Tracy's PSRU would then be operating at about twice 
engine oil pressure. I don't see a real problem with that. The gov could 
be mounted about where the stock Mazda metering pump is mounted to keep 
the height down. Getting engine oil into the prop gov is no problem
with a plate adaptor  as shown in the #11 photo.

Does everybody follow this or do we need a schematic?

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.