Jerry Hey wrote:

Paul,  Here is a cardboard mock up of the intake runner.  The radius is
3 in which is  standard  for 2 in. o.d.   It fits my project just fine
as far as height is concerned.   The length is about 19 inches from the
butterfly to the end as shown. It could be lengthened by extending the
lower leg. I think 22 inches was the target length for 6000 rpm.   The
height of the runner can be reduced some by leaning it toward the
center.   Jerry

Looks feasible Jerry.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.