"The friction-power expenditure is also increased with flow velocity, but in this
case the power varies by as much as the cube of the velocity and never less
than the square."
Ah ha!!! So this is why we where blowing circuit breakers on one and two HP motors
and why it took a five HP motor to pump water through the system at 7000 RPM and
75 gallons a minute. Long passages in the radiator and engine block could
generate considerable HP loses due to friction alone.
Paul Lamar
Paul, This seems an obvious culprit, Hydrodynamic skin friction being even
higher than areodynamic skin friction. If you check I believe that the inner surface
condition is a signifigant factor. The most obvious extreem example being the
HP difference listed in the old machinerys handbook of smooth pipe vs. corrigated
pipe with the same (clear) inner diameter. For max flow we need to make smooth
joints, and use as few as possible. In the old threads above I mentioned the
Mazeier Water Pump, please note everybody that that is the engine pulley driven
pump that Mazeier sells! They list the HP required in a table in their own catalog.
I may well use a remote mount pump but it will be belt or direct drive.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.