"Kent, Russell" wrote:
Jerry Hey wrote:
Paul, here is a mock up of the proposed system with 22 inch runners,
butterfly to bell mouth. It can be fitted under my cowl but it
certainly will not fit under all cowls. Can we lower the height by
using two 90ºs instead of the 180º? Bend radius of the 180 is 3
inches. Bend radius of the 90º is 2 inches. Instead of butt welding
the 90ºs which might cause roughness inside, a sleeve could slipped
over the joint and then welded. Or I can practice my butt welding on
this material until I get dialed in to the point where the interior
walls remain smooth. Or we can join the two pieces with a rubber hose
as we are doing elsewhere in the runner. It is important to me to
be able to fit this system under any cowl. Jerry
Paul responded:
You could tilt the tubes to lower the height. There are some other
ideas I will work on such as a sharper radius 180 degree bend
casting typically used in turbo charger plumbing.
If you're going to the trouble of casting an intake manifold (at least the piece right at the intake ports), is there possible value of bringing the tubes forward and over the PSRU rather than over the block? Seems like there's some usable dead space over the PSRU, and doing so would help keep the engine profile down. And it turns the 180 bend at the ports into a 90 bend, with another 90 bend a few inches upstream.
Russell Kent
I'll take a look that in 3D but it is no promising due to the stagger when
both pipes are the same length.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.